Resonate absorbers are the most powerful of low-frequency absorption technologies. Pound for pound and square foot per square foot, resonant absorbers can not be matched for low-frequency absorption. They are sometimes called resonance absorbers. We are speaking about real low-frequency absorption which represents all frequencies below 100 Hz. Resonant absorbers are different than other absorbers. They work best in areas of high room sound pressure not high sound velocity areas like porous absorbers that handle middle and high frequencies.
Vibrations & Sound Pressure
A resonant absorber is a vibrational system that “runs” on sound pressure. As vibrational science will tell us a resonant absorber is a mass vibrating against a spring. The mass is the cabinet and front wall or diaphragm. The spring is the air inside the cavity of the resonant absorber. If you change the vibrating mass and stiffness of the spring, you can control and tune the resonant absorber to the resonant frequency of choice. The internal mass or cabinet depth determines design frequency. The spring or internal air and cavity are used for achieving the rate of absorption above the unit’s designed for resonant frequency. There are three types of resonant absorbers: Helmholtz and Diaphragmatic and Membrane.
Helmholtz / Membrane
A Helm resonator is a box or tube with an opening or slot at its mouth. Air enters the slot which has a calculated width, length, and depth. The slot is attached to a cabinet or cylinder of different widths and depths. A glass coke bottle is a good example of a Helmholtz resonator. It is a resonant absorber or as some would term a resonance absorber. The frequency or resonance is determined by the slot dimensions along with the cabinet or cylinder depth. Helms are frequency specific and narrow frequency band coverage. A membrane absorber works similar to a diaphragmatic. It has a membrane than vibrates in sympathy to sound pressure. This vibrating membrane is attached to a cabinet which has a certain depth and fills material. A diaphragmatic absorber works similar to a membrane with more performance per square foot.
Calculate Resonant frequency of Helmholtz Slot Absorber
Resonant Frequency Formula
fo = 2160*sqrt(r/((d*1.2*D)*(r+w)))
fo = resonant frequency
r = slot width
d = slat thickness
1.2 = mouth correction
D = cavity depth
w = slat width
2160 = c/(2*PI) but rounded
c = speed of sound in inch/sec
If the gaps vary say 5mm, 10mm, 15mm, 20mm and the wall is angled as shown below, a broad band low mid resonator is created that still keeps the high frequencies alive.
Remember the cavity behind must be airtight!
By working out the different slat widths and slat gaps you can create a broadband low mid resonator at specific frequencies.
Credit : mh-Audio.nl , acousticfields